Low-voltage power supply assembly
1. Remove the following components or assemblies:
●
Formatter cover and cage. See
Formatter cover and cage on page 199.
●
Base unit rear cover. See
Rear cover on page 295.
●
Base unit left rear cover. See
Left rear cover on page 311.
2. Remove two black screws (callout 1) and four silver screws (callout 2) and remove the sheet-metal
shield (callout 3). Remove two screws (callout 4) and remove the sheet-metal lifting handle
(callout 5).
Tip The chassis sheet metal is embossed with a star and arrow that mark the mounting
holes that require black screws.
1
2
3
4
5
Figure 5-252 Remove the low-voltage power supply assembly (1 of 4)
342 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...