High-voltage power supply
1. Remove the following components or assemblies:
●
Base unit left door. See
Left door on page 292
●
Fuser pressure release assembly. See
Fuser pressure release assembly on page 328.
●
Fuser. See
Fuser on page 329.
●
Transfer roller. See
Transfer roller on page 187.
●
Registration assembly. See
Registration assembly on page 325.
●
Paper feed assembly. See
Paper feed assembly (base unit) on page 332.
2. Unplug the power cord from the MFP and the wall receptacle.
3. Disconnect two FFCs (callout 1) and one connector (callout 2).
WARNING! You must unplug the power cord from the MFP and the wall receptacle. The
danger of electrical shock exists from the connector (callout 2) when the power cord is
connected to the MFP.
2
1
Figure 5-259 Remove the high-voltage power supply assembly (1 of 9)
ENWW Print engine (base unit) 347
To Next Page
Loading...