4. Release two bushing tabs to release the top-of-page sensor assembly (SR5). Grasp the assembly
with both hands to prevent the assembly from separating when it is removed. Lift the assembly
straight up and out of the power supply assembly.
1
2
1
Figure 5-260 Remove the high-voltage power supply assembly (2 of 9)
5. Note how the spring is installed on the sensor assembly. Carefully set the sensor assembly aside
where it will not be disturbed. If you must reinstall the spring, make sure that the long leg of the
spring rests on the flag, and that the hook end of the spring is positioned against the bushing.
Figure 5-261 Remove the high-voltage power supply assembly (3 of 9)
348 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...