Lifter drive assembly
1. Remove the following components or assemblies:
●
ADF. See
ADF assembly on page 204.
●
Scanner. See
Scanner assembly on page 232.
●
Stapler/stacker. See
Stapler/stacker assembly on page 254.
●
Formatter cover and cage. See
Formatter cover and cage on page 199.
●
Base unit rear cover. See
Rear cover on page 295.
●
Base unit top cover. See
Top cover on page 312.
●
Base unit right rear cover. See
Right rear cover on page 315.
●
Base unit right rear inner cover. See
Right rear inner cover on page 313.
●
Interconnect PCA assembly. See
Interconnect PCA assembly on page 345.
●
Low-voltage power supply. See
Low-voltage power supply assembly on page 342.
2. Disconnect three connectors (callout 1) and release all of the wire harnesses from the retainer
(callout 2).
1
2
Figure 5-271 Remove the lifter driver assembly (1 of 4)
354 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...