13. Rotate the high-voltage power supply up to install it.
Figure 5-269 Reinstall the high-voltage power supply assembly (2 of 3)
14. After you install the replacement power supply, make sure that the drive gear rotates freely.
Tip If the high-voltage power supply was not correctly seated when it was reinstalled, the
high-voltage contact springs on the chassis might interfere with this gear. This can cause
13.42 Jam or 66.12 error messages to appear on the control panel display when the device
power is turned on after replacing the high-voltage power supply.
Figure 5-270 Reinstall the high-voltage power supply assembly (3 of 3)
ENWW Print engine (base unit) 353
To Next Page
Loading...