11. Remove the loop sensor assembly (SR4) from the power supply and install it on the replacement
high-voltage power supply before you install it.
CAUTION Note how the sensor flag and spring are installed before you remove the sensor
assembly.
Tip Make sure that the flag moves freely after you install the sensor assembly on the
replacement power supply.
Figure 5-267 Remove the high-voltage power supply assembly (9 of 9)
12. It might be easier to reinstall the high-voltage power supply by reaching through the tray cavity and
positioning the assembly at a steep angle to engage the assembly with the MFP chassis.
Tip Look through the fuser cavity while positioning the assembly in the tray cavity.
Figure 5-268 Reinstall the high-voltage power supply assembly (1 of 3)
352 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...