Paper pickup assemblies
NOTE The single tray HCI contains one paper pickup assembly. The multi tray HCI contains
three paper pickup assemblies.
1. Remove the following components or assemblies:
●
HCI right door. See
Right door on page 373.
●
HCI back cover. See
Back cover on page 376.
2. Disconnect three connectors (callout 1) and remove one screw (callout 2).
2
1
Figure 5-307 Remove the HCI paper pickup assembly (1 of 6)
3. Remove two screws (callout 3) and remove the right front cover (callout 4).
3
4
Figure 5-308 Remove the HCI paper pickup assembly (2 of 6)
378 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...