Table 3-34 Manage Trays menu (continued)
First level Values Description
Use Another Tray Enabled*
Disabled
Turns on or off the control-panel prompt to
select another tray when the specified tray is
empty. Two options are available:
Enabled: When this option is selected, the user
is prompted either to add paper to the selected
tray or to choose a different tray.
Disabled: When this option is selected, the user
is not given the option of selecting a different
tray. The product prompts the user to add
paper to the tray that was initially selected.
Alternative Letterhead Mode Disabled*
Enabled
Use this option to load letterhead or preprinted
paper into the tray the same way for all print
jobs, whether you are printing to one side or
both sides of the sheet. When this option is
selected, load the paper as you would for
printing on both sides. See the user
documentation that came with the product for
instructions about loading letterhead for
printing on both sides. When this option is
selected, the product speed slows to the speed
required for printing on both sides.
Duplex Blank Pages Auto*
Yes
Controls how the product handles two-sided
jobs (duplexing). Two options are available:
Auto: Enables Smart Duplexing, which instructs
the product not to process blank pages.
Yes: Disables Smart Duplexing and forces the
duplexer to flip the sheet of paper even if it is
printed on only one side. This might be
preferable for certain jobs that use paper types
such as letterhead or prepunched paper.
Image Rotation Standard
Alternate
Override A4/Letter Yes*
No
Prints on letter-size paper when an A4 job is
sent but no A4-size paper is loaded in the
product (or to print on A4 paper when a letter-
size job is sent but no letter-size paper is
loaded). This option will also override A3-size
paper with ledger-size paper and ledger-size
paper with A3-size paper.
Network Settings menu
To display: At the product control panel, select the Administration menu, and then select the Network
Settings menu.
In the following table, asterisks (*) indicate the factory default setting.
370 Chapter 3 Solve problems ENWW
To Next Page
Loading...