Table 3-35 Network Settings menu
First level Values Description
I/O Timeout Range: 5 – 300 sec
Default = 15
Sets the I/O timeout period in seconds. I/O
timeout refers to the elapsed time before a
print job fails. If the stream of data that the
product receives for a print job is interrupted,
this setting indicates how long the product will
wait before it reports that the job has failed.
Jetdirect Menu See the table that follows for details. These
menus have the same structure. If an additional
HP Jetdirect network card is installed in the USB
port, then both menus are available.
Table 3-36 Jetdirect Menu
First level Second level Third level Fourth level Values Description
Information Print Sec Report Yes
No*
Yes: Prints a page that
contains the current
security settings on
the HP Jetdirect print
server.
No: A security settings
page is not printed.
TCP/IP Enable On*
Off
On: Enables the TCP/
IP protocol.
Off: Disables the TCP/
IP protocol.
Host Name Use the arrow buttons
to edit the host name.
NPIXXXXXX*
An alphanumeric
string, up to 32
characters, used to
identify the product.
This name is listed on
the HP Jetdirect
configuration page.
The default host name
is NPIxxxxxx, where
xxxxxx is the last six
digits of the LAN
hardware (MAC)
address.
ENWW Tools for troubleshooting 371
To Next Page
Loading...