Table 3-36 Jetdirect Menu (continued)
First level Second level Third level Fourth level Values Description
IPV4 Settings Config Method Bootp
DHCP*
Auto IP
Manual
Specifies the method
by which TCP/IPv4
parameters will be
configured on the
HP Jetdirect print
server.
Bootp (Bootstrap
Protocol): Use for
automatic
configuration from a
BootP server.
DHCP (Dynamic Host
Configuration
Protocol): Use for
automatic
configuration from a
DHCPv4 server. If
selected and a DHCP
lease exists, the DHCP
Release menu and the
DHCP Renew menu
are available to set
DHCP lease options.
Auto IP: Use for
automatic link-local
IPv4 addressing. An
address in the form
169.254.x.x is
assigned
automatically.
If you set this option
to the manual setting,
use the Manual
Settings menu to
configure TCP/IPv4
parameters.
Manual Settings
NOTE: This menu is
available only if you
select the Manual
option under the
Config Method menu.
IP Address Enter the address. (Available only if the
Config Method option
is set to the Manual
option.) Configure
parameters directly
from the product
control panel.
Subnet Mask Enter the address.
Default Gateway Enter the address.
372 Chapter 3 Solve problems ENWW
To Next Page
Loading...