Table 3-36 Jetdirect Menu (continued)
First level Second level Third level Fourth level Values Description
Ping Test Dest Type IPv4
IPv6
This test is used to
check network
communications. This
test sends link-level
packets to a remote
network host and
then waits for an
appropriate response.
To run a ping test, set
the following items:
Dest Type
Specify whether the
target product is an
IPv4 or IPv6 node.
Dest IPv4 Range: 0 – 255
Default = 127.0.0.1
Enter the IPv4
address.
Dest IPv6 Select from a provided
list.
Default = : : 1
Enter the IPv6
address.
Packet Size Range: 64 – 2048
Default = 64
Specify the size of
each packet, in bytes,
to be sent to the
remote host.
Timeout Range: 001 – 100
Default = 001
Specify the length of
time, in seconds, to
wait for a response
from the remote host.
Count Range: 0 – 100
Default = 004
Specify the number of
ping test packets to
send for this test.
Select a value from 0
to 100. To configure
the test to run
continuously, select 0.
Print Results Yes
No*
Execute Yes
No*
No: Do not initiate the
selected tests.
Yes: Initiate the
selected tests.
Ping Results Packets Sent Range: 0 – 65535
Default = 00000
Shows the number of
packets sent to the
remote host since the
most recent test was
initiated or
completed.
ENWW Tools for troubleshooting 379
To Next Page
Loading...