Table 3-57 MP modes under the Optimize submenu (continued)
MEDIA TEMP Use ALTERNATE 1to preventing media in the output bin from
sticking together.
UNIFORMITY CONTROL Set to ALTERNATE 1 to improve uniformity on any paper type. Set
to ALTERNATE 2 to improve uniformity on normal and light paper
types. Set to ALTERNATE 3 when the other alternatives do not
correct the problem.
PRE-ROTATION Set to ALTERNATE 1 when horizontal banding occurs with the
drum pitch, or when 53 mm band occurs after leaving engine for a
long period of time.
Set to ALTERNATE 2 when the problems like fade finger (trailing
edge toner starvation) occur after high coverage continuous
printing.
REGISTRATION Set to ALTERNATE when color misregistration occurs.
TRANSFER CONTROL Set to ALTERNATE 1 to reduce primary transfer bias and to
resolve low density or blotchy images. Set to ALTERNATE 2 to
resolve ghosting outlines that look like a finger or fingers. Set to
ALTERNATE 3 when the other alternatives do not correct the
problem.
MOISTURE CONTROL Set to ALTERNATE when image failure occurs due to water drops.
516 Chapter 3 Solve problems ENWW
To Next Page
Loading...