HP MFP CM3530 MFP - Set the billing-code configuration

Set the billing-code configuration
HP MFP Send Fax supports the use of billing codes when sending faxes.
1. On the MFP control panel, touch Administration.
2. Scroll to and touch Initial Setup.
3. Scroll to and touch Fax Setup.
4. Scroll to and touch Fax Send Settings.
5. Scroll to and touch Billing Codes.
6. Touch Custom to open the billing-code screen.
7. Use the up and down arrows to select the minimum number of digits in the billing code.
8. Touch OK to enable the billing-code feature or touch Off to disable the billing-code feature.
NOTE: If the billing-code feature is enabled on the MFP, a billing-code entry is required for walk-
up fax jobs sent from the MFP.
66 Chapter 3 Configuration ENWW