Hardware options installation 12
Removal and replacement tools
In performing hardware configuration, you must have the system screwdriver secured to the front panel
door. All hardware screws used in the server can be removed or tightened by using the system
screwdriver. All spare screws are located on the back side of the front panel door.
The following references and software tools may also be used:
• IPMI Event Log
• Diagnostics software
Server warnings and cautions
WARNING: To reduce the risk of personal injury from hot surfaces, allow drives and internal
system components to cool before touching them.
CAUTION: The server must always be operated with the system covers on. Proper cooling is
not achieved when the system covers are removed.
CAUTION: When installing hardware or performing maintenance procedures requiring
access to internal components, HP recommends that you first back up all server data to avoid
loss.
To Next Page
Loading...
Need help?
General