192
v2c: Specifies SNMPv2c.
v3: Specifies SNMPv3.
Usage guidelines
SNMPv1 and SNMPv2c settings in this command are not supported in FIPS mode.
Configure the SNMP agent with the same SNMP version as the NMS for successful communications
between them.
Examples
# Enable SNMPv3.
<Sysname> system-view
[Sysname] snmp-agent sys-info version v3
Related commands
display snmp-agent sys-info
snmp-agent target-host
Use snmp-agent target-host to configure the SNMP agent to send SNMP notifications (informs or traps)
to a host.
Use undo snmp-agent target-host to remove an SNMP notification target host.
Syntax
Non-FIPS mode:
snmp-agent target-host inform address udp-domain { ip-address | ipv6 ipv6-address } [ udp-port
port-number ] [ vpn-instance vpn-instance-name ] params securityname security-string { v2c | v3
[ authentication | privacy ] }
snmp-agent target-host trap address udp-domain { ip-address | ipv6 ipv6-address } [ udp-port
port-number ] [ vpn-instance vpn-instance-name ] params securityname security-string [ v1 | v2c | v3
[ authentication | privacy ] ]
undo snmp-agent target-host { trap | inform } address udp-domain { ip-address | ipv6 ipv6-address }
par
ams sec
urityname security-string [ vpn-instance vpn-instance-name ]
FIPS mode:
snmp-agent target-host inform address udp-domain { ip-address | ipv6 ipv6-address } [ udp-port
port-number ] [ vpn-instance vpn-instance-name ] params securityname security-string v3
{ authentication | privacy }
snmp-agent target-host trap address udp-domain { ip-address | ipv6 ipv6-address } [ udp-port
port-number ] [ vpn-instance vpn-instance-name ] params securityname security-string v3
{ authentication | privacy }
undo snmp-agent target-host { trap | inform } address udp-domain { ip-address | ipv6 ip
v6-address }
par
ams securityname security-string [ vpn-instance vpn-instance-name ]
Default
No SNMP notification target host is configured.
Views
System view
To Next Page
Loading...
Need help?
General
