HP MSR4080 Configuration Guide

20
•
If a dynamic router port receives a PIMv2 hello message, the aging timer for the port is specified
by the hello message. In this case, the router-aging-time or igmp-snooping
router-aging-time command does not take effect on the port.
•
IGMP group-specific queries originated by the Layer 2 device trigger the adjustment of aging
timers for dynamic member ports. If a dynamic member port receives such a query, its aging
timer is set to twice the IGMP last member query interval. For more information about setting
the IGMP last member query interval on the Layer 2 device, see "Setting the IGMP last member
query interval."
•
You can set the timers globally for all VLANs in IGMP-snooping view or for a VLAN in VLAN
view. For a VLAN, the VLAN-specific configuration takes priority over the global configuration.
Setting the aging timers for dynamic ports globally
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter IGMP-snooping view.
igmp-snooping
N/A
3.
Set the aging timer for
dynamic router ports
globally.
router-aging-time
seconds
The default setting is 260
seconds.
4. Set the global aging timer for
dynamic member ports
globally.
host-aging-time
seconds
The default setting is 260
seconds.
Setting the aging timers for dynamic ports in a VLAN
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter VLAN view.
vlan
vlan-id
N/A
3.
Set the aging timer for
dynamic
router ports in the
VLAN.
igmp-snooping
router-aging-time
seconds
The default setting is 260
seconds.
4.
Set the aging timer for
dynamic member ports in the
VLAN.
igmp-snooping
host-aging-time
seconds
The def
ault setting is 260
seconds.
Configuring static ports
You can configure the following types of static ports:
•
Static member port—When you configure a port as a static member port for a multicast group,
all hosts attached to the port will receive multicast data for the group.
The static member port does not respond to IGMP queries. When you complete or cancel this
configuration on a port, the port does not send an unsolicited IGMP report or leave message.
•
Static router port—When you configure a port as a static router port for a multicast group, all
multicast data for the group received on the port will be forwarded.
To configure static ports:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter Layer 2 Ethernet
interface view or
Layer 2
aggregate interface view.
interface
interface-type
interface-number
N/A

HP MSR4080 Specifications

General

Brand	HP
Model	MSR4080
Category	Network Router
Language	English