HP MSR4080

140
Flags: 0x0
Uptime: 00:08:32
RPF interface: GigabitEthernet1/0/2
List of 1 DF interfaces:
1: GigabitEthernet1/0/1
# Display information about the DF for multicast forwarding on Router B.
[RouterB] display multicast forwarding df-info
Total 1 RP, 1 matched
00001. RP address: 1.1.1.1
Flags: 0x0
Uptime: 00:06:24
RPF interface: GigabitEthernet1/0/3
List of 2 DF interfaces:
1: GigabitEthernet1/0/1
2: GigabitEthernet1/0/2
# Display information about the DF for multicast forwarding on Router C.
[RouterC] display multicast forwarding df-info
Total 1 RP, 1 matched
00001. RP address: 1.1.1.1
Flags: 0x0
Uptime: 00:07:21
RPF interface: LoopBack0
List of 2 DF interfaces:
1: GigabitEthernet1/0/1
2: GigabitEthernet1/0/2
# Display information about the DF for multicast forwarding on Router D.
[RouterD] display multicast forwarding df-info
Total 1 RP, 1 matched
00001. RP address: 1.1.1.1
Flags: 0x0
Uptime: 00:05:12
RPF interface: GigabitEthernet1/0/3
List of 2 DF interfaces:
1: GigabitEthernet1/0/1
2: GigabitEthernet1/0/2
PIM-SSM configuration example
Network requirements
As shown in Figure 48:
•
OSPF runs on the network.
•
The receivers receive VOD information through multicast. The receiver groups of different
organizations form stub networks, and one or more receiver hosts exist in each stub network.
The entire PIM domain operates in the SSM mode.
•
Host A and Host C are multicast receivers on two stub networks.