HP MSR930 - 4 G-LTE;3 G Interface Provides Backup to Primary Connection; Verify; Troubleshoot; Determine Software Revision

Configuration guide | HP MSR930 Verizon 4G-LTE/3G Router Series
4G-LTE/3G interface provides backup to primary connection
This configuration describes how to make the 4G-LTE/3G interface a backup to the Gigabit Ethernet interface 1:
interface gigabitethernet 0/1 port link-mode route
ip address 10.10.1.3 24
standby interface Cellular-Ethernet1/0 standby timer delay 10 10
quit
ip route-static 0.0.0.0 0.0.0.0 gigabitethernet0/1 10.10.1.1
Connect an Ethernet cable from the HP MSR930 Router Series GE0/1 port to the device with a connection to the Internet
(GW 10.10.1.1).
Verify
Verify 4G-LTE/3G interface as a primary dial-up connection:
• From system console, enter: “ping www.google.com”
– You should get replies from Cellular-Ethernet1/0 interface. Verify 4G-LTE/3G interface as backup connection
• Disconnect primary connection
• From system console, enter: “ping www.google.com”
– You should get replies from Cellular-Ethernet 1/0 interface. Verify 4G-LTE/3G interface with permanent connection
• Do not enter anything on the HP MSR930 Router Series system console for a period longer than the “dialer timer idle xxx”
command
• The Cellular-Ethernet 1/0 interface remains with a status of up
• From system console, enter: “ping www.google.com”
– You should get replies from Cellular-Ethernet 1/0 interface
Troubleshoot
Determine software revision
The next thing to do is to make sure the device is having the latest supported software release. In this procedure, you will
compare the software revision that is shown on the device against the latest supported software revision.
Determine the current release running on the device:
display version
Determine the latest supported release of the device:
Use your laptop connected to a network with Internet access, go to the HP Customer Care—Product Support
website
In the box that says “Enter your product number”: For example, enter “MSR30”.
Expand “Networking”, and click on the model you have Click on “Downloads and software”.
Click on the arrows under “Select” for the model you have.
The latest supported software revision is the version with a status of “Current”. If the latest supported software revision is
newer than the version currently running on the device you are using, we recommend that you upgrade the device.
Click on the arrows under “Select” for the version with a status of “Current” Save the zip file to your laptop.
The zip file will contain the software .bin file for the router and the release notes.
12