HP MSR930 Configuration Guide

Configuration guide | HP MSR930 Verizon 4G-LTE/3G Router Series
The following software is required:
• HP MSR930 Router Series Comware software, version 5.20.106
The following tools are required:
• Windows® laptop with minimum 2 GB RAM (quantity 1)
• System console cable included with MSR
• USB to DB9 serial adapter cable tools for the laptop
• Terminal emulation application
• FTP client
• Figure 2 illustrates the connectivity of a laptop and an HP MSR930 Router Series when performing initial configuration
• A USB port on the laptop is connected to the system console port of the HP MSR Router Series using a USB to serial
adapter (available at any electronics hardware store) and the HP MSR930 System Console Cable
• An Ethernet cable is connected between the Ethernet port on the laptop and the GE1 interface on the HP MSR930
Router Series
Network diagram
The diagram below illustrates the connectivity of an HP MSR930 4G-LTE/3G (CDMA) with a 4G-LTE interface that uses a
4G-LTE network as its primary connection to the WAN or Internet.
Figure 2. Using 4G-LTE/3G as primary access to Internet
4G-LTE card
Laptop
HP IP phone with 5 V
power supply
Ethernet
cable
Console
cable
HP MSR930 Router Series
4G-LTE network
Internet
3

HP MSR930 Specifications

General

Brand	HP
Model	MSR930
Category	Network Router
Language	English