Configuration guide | HP MSR930 Verizon 4G-LTE/3G Router Series
Login to router using CLI
With PuTTY running and connected to the HP MSR Router Series, you should see text being displayed.
• Press Enter once to display a “username:” prompt
• The default username/password for new HP MSR Router Series is “admin” with no password
• The default username/password for HP MSR Router Series that may have been previously configured in the
HP FlexBranch demo environment is “admin” with a password of “admin”
• Enter the username and press Enter
• Enter the password and press Enter
• Monitor<prompt> mode is enabled
Save current configuration
If you have a device with a previous configuration, it is recommended to save the current configuration with a different file
name other than “startup.cfg” and then reset to factory defaults. Then you can begin your configuration knowing that the
previous configuration will not conflict with the new configuration.
• Save the device configuration:
save
Save configuration? y
Backup configuration
Backup the current configuration, follow these steps:
• From the device system console, where “clean.bak” is an example:
rename startup.cfg clean.bak
Reset to factory defaults or previously saved configuration
Start from a factory defaults condition to prevent interference of other features under test.
• From the device system console in monitor mode <prompt>:
• Reset the device to factory defaults:
reset saved-configuration
The saved configuration file will be erased. Are you sure? [Y/N]: y
• Alternatively, to set the device to a previously saved configuration:
rename clean.bak startup.cfg
• Or you can enter (for example):
startup saved-configuration demo.cfg
• Display the current startup configuration:
display startup
• Reboot the device:
reboot
This command will reboot the device. Current configuration will be lost, save
current configuration? [Y/N]: n
This command will reboot the device. Continue? [Y/N]: y
5
To Next Page
Loading...
Need help?
General
