HP mt43

10. If it is necessary to replace the display covers or hinges, remove the Phillips M2.0×3.0 screw (1) that
secures the hinge covers to the display enclosure, and then remove the hinge covers (2).
11. Remove the 6 Phillips M2.0x2.0 screws that secure the hinges to the display enclosure (3), and then
remove the display hinges from the display enclosure (4).
Display hinge covers and hinges are available in the Hinge Kit using spare part number 821166-001.
12. If it is necessary to replace the display/webcam cable, lift the display/webcam cable assembly (1) from
the routing path on the side of the display enclosure (2), and then remove the cable (3).
The display cable is available in the Cable Kit using spare part number 914381-001.
Component replacement procedures 57