HP MultiSeat t100 - Thin Client User Manual

6. Place the new hard drive in the carrier then slide the hard drive back so that it seats in the SATA
connector on the carrier's circuit board. Be sure the connector on the hard drive is pressed all
the way into the connector on the carrier's circuit board.
Figure 5-41 Replacing the Hard Drive
7. Replace the four screws in the bottom of the carrier to hold the drive securely in place.
Figure 5-42 Replacing the Security Screws
Installing and Removing Drives 65

HP MultiSeat t100 - Thin Client Specifications

General

Brand	HP
Model	MultiSeat t100 - Thin Client
Category	Server
Language	English