Commands and Responses
HP NonStop TMF Management Programming Manual—540140-008
5-82
DUMP FILES
Tokens in Command Buffer
ZTMF-TKN-Fileset
specifies the name of an audited file to be dumped to tape or disk, or the name of a
file of filenames (each filename in the specified file being the name of an audited
file to be dumped).
The name of a file of filenames must be enclosed within angle brackets (< and >),
and it cannot contain wildcards.
Each line in a file of filenames contains a vol-pattern.subvol-pattern.filename-
pattern starting in the first column. A filename does not have to be fully qualified (if
necessary, the defaults specified by the ZTMF-TKN-FilesetDefault token are used
to expand the filename). Comments beginning with a minus sign in column 1 and
blank lines are allowed. Any characters following a filename pattern are comments.
This token is optional. When specifying names of audited files to be dumped,
multiple occurrences of this token are allowed. When specifying the name of a file
of filenames, however, only one occurrence of this token is allowed. The names of
two different files of filenames can be specified in ZTMF-TKN-Fileset and ZTMF-
TKN-NotFileset tokens within the same command buffer.
ZTMF-TKN-NotFileset
specifies the name of an audited file not to be dumped, or the name of a file of
filenames (each filename in the specified file being the name of an audited file not
to be dumped).
The name of a file of filenames must be enclosed within angle brackets (< and >),
and it cannot contain wildcards.
Each line in a file of filenames contains a vol-pattern.subvol-pattern.filename-
pattern starting in the first column. A filename does not have to be fully qualified (if
necessary, the defaults specified by the ZTMF-TKN-FilesetDefault token are used
to expand it). Comments beginning with a minus sign in column 1 and blank lines
are allowed. Any characters following a filename pattern are comments.
This token is optional. If this token is present, however, the ZTMF-TKN-Fileset
token must also be present.
When specifying names of audited files not to be dumped, multiple occurrences of
this token are allowed. When specifying the name of a file of filenames, however,
only one occurrence of this token is allowed. The names of two different files of
filenames can be specified in ZTMF-TKN-Fileset and ZTMF-TKN-NotFileset tokens
within the same command buffer.
To Next Page
Loading...
