To Next Page

To Previous Page

Commands and Responses

HP NonStop TMF Management Programming Manual—540140-008

5-86

DUMP FILES

ZUnloadMedia

for dumps to tape, specifies whether the tape is unloaded after the dump

process finishes writing to the tape. The following values are valid:

If you omit this field, its default value is ZSPI-VAL-True.

ZMedium

specifies the type of storage media on which this dump is recorded. This field

is required. The following values are valid:

ZMaxDumpSize

for dumps to disk, specifies the maximum size of the dump. Valid are in the

range from 20x1024 bytes to 10x1024x1024 bytes. If this field is null, the

default value is determined at run time by TMF.

If you omit this field, the default value is 0.

ZSystemName

for dumps to tape, specifies the name of the system on which the audit dump

process performs automatic volume recognition (AVR) on the first parallel copy.

If you omit this field, the default value is the name of the local system.

If you specify a remote node for dumps to tape, Guardian labeled-tape

processing must be enabled on that node and must be running on RVU C30 or

later of the NonStop OS. TMF, however, need not be configured or running on

the remote node.

ZSystemName2

for dumps to tape, specifies the name of the system on which the audit dump

process performs automatic volume recognition (AVR) on the second parallel

copy.

If you omit this field, the default value is the name of the local system.

If you specify a remote node for dumps to tape, Guardian labeled-tape

processing must be enabled on that node and must be running on RVU C30 or

later of the NonStop OS. TMF, however, need not be configured or running on

the remote node.

ZSPI-VAL-True Tapes are unloaded after use.

ZSPI-VAL-False Tapes are not unloaded after use.

ZTMF-VAL-MediumTape Tape storage media.

ZTMF-VAL-MediumMagneticDisk Magnetic disk storage media.

HP NonStop TMF User Manual

Questions and Answers: