Commands and Responses
HP NonStop TMF Management Programming Manual—540140-008
5-100
INFO AUDITDUMP
ZVerifyTape
specifies whether tape verification is performed after a tape is written. The
following values are possible:
ZBlockSize
specifies the length of tape data blocks.
ZUnloadMedia
specifies whether the tape is unloaded after the dump process finishes writing
to the tape. The following values are possible:
ZMedium
specifies the type of storage media on which the audit dump is recorded. The
following values are possible:
ZSystemName
specifies the name of the system on which the audit dump process performs
automatic volume recognition (AVR).
ZSystemName2
specifies the name of the system on which the audit dump process performs
automatic volume recognition (AVR) for the second parallel copy.
Usage Guidelines
Any user can issue this command.
You can enter this command at any time, whether or not TMF has been started.
Multiple response records are allowed to enable the command to return all the
requested information.
If the specified audit trail has not been configured for dumping, the ZTMF-ERR-
ATNotDumping error is returned and the ZTMF-DDL-Info-AuditDump extensible
structured token is not included in the response record.
You can remove the disk media attributes of the dump process using the INFO
ATDUMPDM command.
ZSPI-VAL-True Tapes are verified
ZSPI-VAL-False Tapes are not verified
ZSPI-VAL-True Tapes are unloaded after use
ZSPI-VAL-False Tapes are not unloaded after use
ZTMF-VAL-MediumTape Tape storage media
ZTMF-VAL-MediumMagneticDisk Magnetic disk storage media
To Next Page
Loading...
Need help?
General