Commands and Responses
HP NonStop TMF Management Programming Manual—540140-008
5-118
INFO DUMPS
ZMasterSequence
ZDataSequence
are not valid for command buffers.
ZDumpStatus
specifies the dump status to search for. The following values are valid:
If you omit this field, the default is all three.
ZMediaStatus
This field is not valid for command buffers.
ZSortSelect
specifies the order in which the dump entries are to be returned. The following
values are valid:
If you omit this field, the default is ZTMF-VAL-ByName.
ZTimeStamp
ZSystemNumber
ZMedia
are not valid for command buffers.
ZMedium
specifies the type of storage medium to search for. The following values are
valid:
If you omit this field, the default is both.
ZDiskMedia
This field is not valid for command buffers.
ZTMF-VAL-Assigned The tape volume contains valid dumps
ZTMF-VAL-Released The contents of the tape volume is not required
for file recovery
ZTMF-VAL-Invalid The tape volume cannot be used for file
recovery
ZTMF-VAL-BySerial The selected dumps are returned in descending
numeric order by serial number
ZTMF-VAL-ByName The selected dumps are returned alphabetically
by file name
ZTMF-VAL-MediumTape Tape storage media
ZTMF-VAL-MediumMagneticDisk Magnetic disk storage media
To Next Page
Loading...
Need help?
General