Commands and Responses
HP NonStop TMF Management Programming Manual—540140-008
5-122
INFO MEDIA
Tokens in Command Buffer
ZTMF-TKN-Media
specifies the name of a tape volume for which the configured values are to be
returned. To specify all media, set name to “* “ (that is, an asterisk followed by
four spaces), partnumber to -1, and copynumber to -1.
ZTMF-MAP-Info-Media
is an extensible structured token specifying the attributes that are to be used in
selecting the tape volumes about which information is to be returned. This token is
required; only one occurrence is allowed. If multiple attributes are specified,
information is returned only for volumes that meet all the selection criteria. This
token contains the following fields:
ZMediaName
is not valid in command buffers.
ZMedium
specifies the type of storage media. The value of this field should be ZTMF-
VAL-MediumTape for a tape volume.
ZMediaStatus
specifies the selection of tape volumes that have the particular status. The
following values are valid:
ZTMF-VAL-Assigned The tape volume contains valid dumps
ZTMF-VAL-Released The content of the tape volume is not required
for file recovery
ZTMF-VAL-Scratch The tape volume can be used for dumping
files
ZTMF-VAL-Bad The tape volume is defective and cannot be
used
To Next Page
Loading...
