HP NonStop TMF User Manual

Commands and Responses
HP NonStop TMF Management Programming Manual—540140-008
5-127
INFO PROCESS
ZDebug
specifies whether the process enters the DEBUG or INSPECT program soon
after it starts. The following values are possible:
If this field is null, the value is ZSPI-VAL-False.
ZInspect
specifies which debugger the process enters soon after it starts. This field is
only valid if ZDebug is ZSPI-VAL-True. The following values are possible:
ZExtendedSegSize
specifies the size, in megabytes, of the process’ extended segment. The first
number is the initial size of the extended segment. The second number is the
growth limit for the extended segment. When the process is using its default
values, “-1, -1” is returned in the ZExtendedSegSize field.
ZPfsSize
Zero is always returned. KMSF is always used for TMF processes.
ZDfltExtendedSegSize
specifies the size, in megabytes, of the process' default extended segment.
The first number is the initial size of the extended segment. The second
number is the growth limit for the extended segment.
Usage Guidelines
Any user can issue this command.
You can enter this command at any time, whether or not TMF has been started.
ZSPI-VAL-True The process enters DEBUG or INSPECT soon
after starting
ZSPI-VAL-False The process does not enter DEBUG or INSPECT
ZSPI-VAL-True The process enters the INSPECT program
ZSPI-VAL-False The process enters the DEBUG program

HP NonStop TMF Specifications

General

Brand	HP
Model	NonStop TMF
Category	Software
Language	English