Commands and Responses
HP NonStop TMF Management Programming Manual—540140-008
5-155
STATUS ATFILE
ZTMF-VAL-ATFilePreallocated
specifies preallocated files. These files are placeholders used to guarantee that
disk space configured for the audit trail is not consumed by other applications.
Preallocated files are made into active files as audit-trail space is consumed.
Preallocated files are used in preference to available files when a new audit file
is needed in the audit trail.
ZTMF-VAL-ATFileOverflow
specifies overflow files. These files are similar to active files but they have
been copied onto one of the overflow volumes configured for the audit trail.
This happens when the amount space consumed by active files exceeds the
overflow threshold specified for the audit trail.
ZTMF-VAL-ATFileOverflowing
specifies a file in the process of being copied to an overflow volume.
ZTMF-VAL-ATFileRestore
specifies restore files. These files have been restored to disk from an archive
copy for use by a TMF recovery process—or an audit-reading application.
ZTMF-VAL-ATFileRestoring
specifies a file in the process of being restored to disk from an archive copy for
use by a TMF recovery process—or an audit-reading application.
ZTMF-TKN-ATFileDumpStatus
specifies the dump status used to select which audit-trail files are to be returned.
This token is optional; multiple occurrences are allowed.
If multiple dump status values are specified, information is returned on all files that
meet any of the specified status values (that is, the values are logically “or-ed”). If
you omit this token, then information is returned on all files.
This token is used with ZTMF-TKN-ATFileStatus. Information is returned only on
files that meet the selection criteria specified in both tokens, (that is, the two tokens
are logically “and-ed”).
The following values are valid:
ZTMF-VAL-DumpStatusCurrent
specifies the current file. This is the file to which the audit trail is currently being
written. Dumping cannot take place until the file is no longer being modified.
ZTMF-VAL-DumpStatusDumping
specifies a file in the process of being copied to archive media by the
AUDITDUMP process, or a file that is next to be dumped.
To Next Page
Loading...
Need help?
General