Commands and Responses
HP NonStop TMF Management Programming Manual—540140-008
5-162
STATUS AUDITTRAIL
Tokens in Command Buffer
ZTMF-TKN-AuditTrailId
specifies the audit trail about which status information is to be returned. This token
is optional; multiple occurrences are allowed. The following values are valid:
If you omit this token, the default is all audit trails.
Tokens in Response Buffer
ZTMF-TKN-AuditTrailId
specifies the audit trail for which status information is returned.
Each audit trail is returned in a separate response record. The response records
can be spread across multiple replies, or multiple response records can be
contained in a single reply, depending on the value of ZTMF-TKN-MaxResp and
the size of the reply buffer. If multiple response records are contained in a single
reply buffer, they are each contained in a data list.
ZTMF-TKN-HeldFileName
specifies the name of the oldest audit-trail file that cannot yet be reused or purged
from the active or overflow-audit volume by TMF. This file is said to be pinned
(retained) on disk. There is always at least one such audit-trail file on disk.
ZHoldingRenameReason contains the reason the file is needed.
If ZHoldingRenameReason has the value ZTMF-VAL-HeldRsnDpPermission, then
ZTMF-TKN-HoldingVolume specifies the name of the disk process that has not
given permission to rename the file.
ZTMF-TKN-HoldingVolume
specifies the name of the disk process that has not given permission to rename the
file. This token is present only if the ZHoldingRenameReason field has the value
ZTMF-VAL-HeldRsnDpPermission.
ZTMF-TKN-AuditFileName
specifies the name of the current audit-trail file.
ZTMF-VAL-Mat Master audit trail
ZTMF-VAL-Aux01 Auxiliary audit trail #1
ZTMF-VAL-Aux02 Auxiliary audit trail #2
. . .
ZTMF-VAL-Aux015 Auxiliary audit trail #15
ZTMF-VAL-WildAuditTrailId All audit trails
To Next Page
Loading...
Need help?
General