To Next Page

To Previous Page

Commands and Responses

HP NonStop TMF Management Programming Manual—540140-008

5-164

STATUS AUDITTRAIL

ZCannotRollover

if true, specifies that the audit disk process cannot find an available audit-trail

file when the current file has become full.

ZAuditHold

if true, specifies that TMF is not allowing further audit generation because there

is very little room left in the audit trail. This condition must be alleviated by

either adding an overflow-audit volume or increasing the audit-trail capacity.

ZCommitHoldGlobalState

specifies the current TMP commit-hold status. The following values are

possible:

ZCommitHold

specifies the current status of commit-hold mode for the specified audit trail.

The following values are possible:

HeldRsnOldTransExists At least one active transaction might have sent

an audit record to this audit-trail file. The audit-

trail file remains on the active or overflow-audit

volume in case the transaction aborts, in which

case the file is needed by the backout process.

HeldRsnVolumeDown The volume on which the audit-trail file resides

is down, so TMF cannot perform the operation

needed to release the file.

HeldRsnRDF RDF requested the pinning of the file on disk,

and eventually releases the file.

ZTMF-VAL-ZLTCH-UnConfigured Not yet configured.

ZTMF-VAL-ZLTCH-On On.

ZTMF-VAL-ZLTCH-Off Off.

ZTMF-VAL-ZLTCH-Activate Activated.

ZTMF-VAL-ZLTCH-Suspend Suspended.

ZTMF-VAL-ZLTCH-UnConfigured Not yet configured.

ZTMF-VAL-ZLTCH-On On.

ZTMF-VAL-ZLTCH-Off Off.

ZTMF-VAL-ZLTCH-Activate Activated.

ZTMF-VAL-ZLTCH-Reviving Reviving.

Value (ZTMF-VAL- ) Description

HP NonStop TMF User Manual

Questions and Answers: