Commands and Responses
HP NonStop TMF Management Programming Manual—540140-008
5-180
STATUS OPERATION
Usage Guidelines
Any user can issue this command.
You can enter this command at any time, whether or not TMF has been started.
The operation numbers generated are re-used, to keep the number of digits to just one
or two as an aid in remembering these numbers; after the highest number allowed
(100) is assigned, the subsystem returns to the lowest possible number (1) to identify
the next operation. To obtain information about an operation number that has been
reused, see the EMS log.
To Next Page
Loading...
Need help?
General