HP NonStop TMF User Manual

Commands and Responses
HP NonStop TMF Management Programming Manual—540140-008
5-193
STATUS TMF
ZHungTrans
specifies whether a hung transaction exists. The following values are possible:
ZTransactionRate
specifies the current TMF transaction rate in hundredths of a transaction per
second. For example, a value of 300 specifies 3 transactions per second.
ZCommitHold
specifies the current status of commit-hold for TMF. The following values are
possible:
ZCommitHoldTime
This token is valid only when ZCommitHold is “activate” or “suspend.” This
token specifies the earliest time at which the audit trail went into its current
state.
ZActivatedTrails
specifies the bit mask of the audit trails that have commit-hold “activate.” When
the audit trail's bit is on, then at least one volume's state is either “activate” or
“reviving.”
ZSuspendReason
This token is valid only when ZCommitHold is “suspend.” This token specifies
why commit-hold was suspended. The following values are possible:
ZSPI-VAL-True Hung transactions exist.
ZSPI-VAL-False There are no hung transactions.
ZTMF-VAL-ZLTCH-UnConfigured Not yet configured.
ZTMF-VAL-ZLTCH-On On.
ZTMF-VAL-ZLTCH-Off Off.
ZTMF-VAL-ZLTCH-Activate Activated.
ZTMF-VAL-ZLTCH-Suspend Suspended.
ZTMF-VAL-ZLTCH-SuspendTimeout The commit-hold timer expired.
ZTMF-VAL-ZLTCH-SuspendUser The user suspended commit-
hold mode.
ZTMF-VAL-ZLTCH-SuspendDualFail A dual failure of a mirrored
audit-trail pair occurred.

HP NonStop TMF Specifications

General

Brand	HP
Model	NonStop TMF
Category	Software
Language	English