Event Messages
HP NonStop TMF Management Programming Manual—540140-008
6-49
Descriptions of Event Messages
92: ZTMF-EVT-CantUndoAlterAT
An operator or subsystem control program (SPI requester) issued an ALTER
AUDITTRAIL command, but the command failed and some of its effects could not be
undone.
Additional Unconditional Tokens
ZTMF-TKN-EVTHDR-ProcessType
identifies the TMF process that generated the event. For this event, the value of
this token is ZTMF-VAL-PROC-TMP.
ZTMF-TKN-AuditTrailID
is the subject token of the event message, and it specifies which audit trail the
message applies to. The values are:
ZEMS-TKN-Emphasis
is set to True for this event.
Effect
The previous audit trail configuration might be corrupted, further audit trail configuration
might not be possible, and you might not be able to start TMF.
Additional Unconditional Tokens
ZTMF-TKN-EVTHDR-ProcessType token-type ZSPI-TYP-Enum.
ZTMF-TKN-AuditTrailID token-type ZSPI-TYP-Enum.
ZEMS-TKN-Emphasis token-type ZSPI-TYP-Boolean.
Event-Message Text
Cannot UNDO the effects of a failed ALTER AUDITTRAIL for the
ZTMF-TKN-AuditTrailID Audit Trail.
ZTMF-VAL-Mat Master audit trail
ZTMF-VAL-Aux01 Auxiliary audit trail #1
ZTMF-VAL-Aux02 Auxiliary audit trail #2
. . .
ZTMF-VAL-Aux15 Auxiliary audit trail #15
To Next Page
Loading...
