HP NonStop TMF - Page 331

Event Messages
HP NonStop TMF Management Programming Manual—540140-008
6-59
Descriptions of Event Messages
97: ZTMF-EVT-ATAlterFPV
An operator or subsystem control program (SPI requester) issued an ALTER
AUDITTRAIL command, redefining the FILESPERVolume attribute as shown in the
message.
Additional Unconditional Tokens
ZTMF-TKN-EVTHDR-ProcessType
identifies the TMF process that generated the event. For this event, the value of
this token is ZTMF-VAL-PROC-TMP.
ZTMF-TKN-AuditTrailID
is the subject token of the event message, and it specifies which audit trail the
message applies to. The values are:
ZTMF-TKN-ATFilesPerVol
specifies the new value configured for the attribute.
Effect
The new FILESPERVolume attribute takes effect immediately.
Recommended Action
Informative message only; no corrective action is needed.
Additional Unconditional Tokens
ZTMF-TKN-EVTHDR-ProcessType token-type ZSPI-TYP-Enum.
ZTMF-TKN-AuditTrailID token-type ZSPI-TYP-Enum.
ZTMF-TKN-ATFilesPerVol token-type ZSPI-TYP-Int.
ZEMS-TKN-Emphasis token-type ZSPI-TYP-Boolean.
Event-Message Text
FilesPerVol attribute of ZTMF-TKN-AuditTrailID Audit Trail
altered to ZTMF-TKN-ATFilesPerVol.
ZTMF-VAL-Mat Master audit trail
ZTMF-VAL-Aux01 Auxiliary audit trail #1
ZTMF-VAL-Aux02 Auxiliary audit trail #2
. . .
ZTMF-VAL-Aux15 Auxiliary audit trail #15