HP NonStop TMF - Page 402

Event Messages
HP NonStop TMF Management Programming Manual—540140-008
6-130
Descriptions of Event Messages
148: ZTMF-EVT-StartTmfParameters
An operator or subsystem control program (SPI requester) issued a Start TMF
command.
Additional Unconditional Tokens
ZTMF-TKN-EVTHDR-ProcessType
is the subject token of the event message, and it identifies the TMF process that
generated the event. The value of this token for this event is ZTMF-VAL-
PROC-TMP.
ZEMS-TKN-Emphasis
is set to True for this event.
Additional Conditional Tokens
ZTMF-TKN-TRANSALLOWOPTION
if present, specifies whether transaction processing is enabled or disabled. The
values are:
ZTMF-VAL-TRANSALLOW-ENABLE
ZTMF-VAL-TRANSALLOW-DISABLE
ZTMF-TKN-DISASTERRECOVERY
if present, specifies that disaster recovery mode is enabled.
Additional Unconditional Tokens
ZTMF-TKN-EVTHDR-ProcessType token-type ZSPI-TYP-Enum.
ZEMS-TKN-Emphasis token-type ZSPI-TYP-Boolean.
Additional Conditional Tokens
ZTMF-TKN-TRANSALLOWOPTION token-type ZSPI-TYP-Enum.
ZTMF-TKN-DISASTERRECOVERY token-type ZSPI-TYP-Enum.
Event-Message Text
Start TMF parameters: ZTMF-TKN-TRANSALLOWOPTION TRANSACTIONS.
or
Start TMF parameters: DISASTER RECOVERY MODE.
or
Start TMF parameters: None.