Event Messages
HP NonStop TMF Management Programming Manual—540140-008
6-248
Descriptions of Event Messages
253: ZTMF-EVT-ADAlterBlockSize
An operator or subsystem control program (SPI requester) issued an ALTER
AUDITDUMP command, specifying a new BLOCKSIZE attribute value.
Additional Unconditional Tokens
ZTMF-TKN-EVTHDR-ProcessType
identifies the TMF process that generated the event. The value of this token for
this event is ZTMF-VAL-PROC-TMP.
ZTMF-TKN-AuditTrailID
is the subject token of the event message, and it specifies which audit trail the
message applies to. The values are:
ZTMF-TKN-ATDumpBlockSize
specifies the new value of the BLOCKSIZE attribute for audit dumping by the
designated audit trail.
Effect
The new attribute value takeS effect immediately.
Recommended Action
Informative message only; no corrective action is needed.
Additional Unconditional Tokens
ZTMF-TKN-EVTHDR-ProcessType token-type ZSPI-TYP-Enum.
ZTMF-TKN-AuditTrailID token-type ZSPI-TYP-Enum.
ZTMF-TKN-ATDumpBlockSize token-type ZSPI-TYP-Int.
Event-Message Text
AuditDump BLOCKSIZE value for the ZTMF-TKN-AuditTrailID
Audit Trail altered to ZTMF-TKN-ATDumpBlockSize.
ZTMF-VAL-Mat Master audit trail
ZTMF-VAL-Aux01 Auxiliary audit trail #1
ZTMF-VAL-Aux02 Auxiliary audit trail #2
. . .
ZTMF-VAL-Aux15 Auxiliary audit trail #15
To Next Page
Loading...
