Event Messages
HP NonStop TMF Management Programming Manual—540140-008
6-349
Descriptions of Event Messages
327: ZTMF-EVT-OperatorReason
If TMVIEW is installed, this event is generated whenever an operator uses TMVIEW
to initiate an operation for which TMVIEW requires that a reason be entered for doing
so. This event is useful in reconstructing the sequence of operator actions involved in a
particular situation.
Additional Unconditional Tokens
ZTMF-TKN-EVTHDR-ProcessType
identifies the TMF process that generated the event. The value of this token for
this event is dynamic.
ZTMF-TKN-Obj
Identifies the object the command affected (such as ZTMF-OBJ-TMF).
ZTMF-TKN-Cmd
Identifies the command the operator issued (such as ZTMF-CMD-STOP).
ZTMF-TKN-Reason
Contains the reason text entered by the operator.
Effect
The operation is performed.
Recommended Action
Informative message only; no corrective action is needed.
Additional Unconditional Tokens
ZTMF-TKN-EVTHDR-ProcessType token-type ZSPI-TYP-Enum.
ZTMF-TKN-Obj token-type ZSPI-TYP-Enum.
ZTMF-TKN-Cmd token-type ZSPI-TYP-Enum.
ZTMF-TKN-Reason token-type ZSPI-TYP-String.
ZEMS-TKN-Emphasis token-type ZSPI-TYP-Boolean.
Event-Message Text
TMAgent object ZTMF-TKN-Obj, command ZTMF-TKN-Cmd,
ZTMF-TKN-Reason.
To Next Page
Loading...
