Error and Warning Messages
HP NonStop TMF Management Programming Manual—540140-008
7-15
Errors
141 ZTMF-ERR-NOSTATEWITHOPERNUM
A STATUS OPERATIONS command that specified the STATE parameter also
specified an operation number.
The ZTMF-TKN-OPERATIONNUM token supplied within the error list
provides additional information.
142 ZTMF-ERR-NOTIMEWITHOPERNUM
A STATUS OPERATIONS command that specified the BEGINTIME parameter
also specified an operation number.
The ZTMF-TKN-OPERATIONNUM token supplied within the error list
provides additional information.
143 ZTMF-ERR-INVALIDFILESET
The command specified a file-set, but did not follow the syntax rules for
identifying file-sets.
144 ZTMF-ERR-CANTCANCELOPERNUM
A CANCEL OPERATIONS command attempted to cancel a TMF operation
other than a file recovery or dump files operation.
The ZTMF-TKN-OPERATIONNUM token supplied within the error list
provides additional information.
145 ZTMF-ERR-MISSINGOPERNUMTKN
The command expected the token ZTMF-TKN-OPERATIONNUM, but it wasn’t
present.
146 ZTMF-ERR-MUSTSPECIFYDUMPSERIAL
The command expected the token ZTMF-TKN-DUMPSERIAL, but it wasn’t
present.
147 ZTMF-ERR-NOWILDWITHDUMPSERIAL
The command failed because a wild card value was listed as well as specific
dump serial numbers.
148 ZTMF-ERR-MUSTSPECIFYOLDDMLOC
The command expected the token ZTMF-TKN-OLDDMLOC, but it wasn’t
present.
To Next Page
Loading...
