Error and Warning Messages
HP NonStop TMF Management Programming Manual—540140-008
7-29
Errors
319 ZTMF-ERR-TOOMANYAUDITDUMPDISK
This error is returned when an ADD DUMPS command is issued for an audit
dump, but more than one DISKMEDIA option was specified.
320 ZTMF-ERR-DISKPARTOUTOFSEQUENCE
The specified DISKMEDIA entry is out of sequence with the other
DISKMEDIA entries listed—or with the DISKMEDIA entries already added to
the TMF catalog.
323 ZTMF-ERR-ATALREADYEXISTS
This is returned by an ADD AUDITTRAIL command when the specified ZTMF-
TKN-AUDITTRAILID already exists in the configuration.
The response record includes a ZTMF-TKN-AUDITTRAILID token containing
the offending value. There is no error list.
324 ZTMF-ERR-PREVATNOTCONFIG
This is returned by an ADD AUDITTRAIL command when the specified ZTMF-
TKN-AUDITTRAILID is not one greater than the last audit trail currently
configured. The trails must be added in order, starting with ZTMF-VAL-MAT,
then ZTMF-VAL-AUX01, ZTMF-VAL-AUX02, and through to ZTMF-VAL-
AUX15.
The response record includes a ZTMF-TKN-AUDITTRAILID token containing
the offending value. There is no error list.
325 ZTMF-ERR-ATNOACTIVEVOLS
This is returned by ADD and ALTER AUDITTRAIL commands if successful
completion of the command would result in no active volumes configured for the
trail. In the case of the ADD command, no ZTMF-TKN-ACTIVEVOLUME
tokens were specified. For the ALTER command, the token ZTMF-TKN-
DELACTIVEVOLUME was specified for all currently configured active
volumes, but no ZTMF-TKN-ADDACTIVEVOLUME tokens were specified.
The response record includes a ZTMF-TKN-AUDITTRAILID token specifying
the audit trail which was being added/altered. There is no error list.
326 ZTMF-ERR-ATNORESTOREVOLS
This is returned by ADD and ALTER AUDITTRAIL commands if successful
completion of the command would result in no restore volumes configured for
the trail, which is configured for audit dumping. In the case of the ADD
command, no ZTMF-TKN-RESTOREVOLUME tokens were specified. For the
ALTER command, the token ZTMF-TKN-DELRESTOREVOLUME was
specified for all currently configured active volumes, but no ZTMF-TKN-
ADDRESTOREVOLUME tokens were specified.
To Next Page
Loading...
Need help?
General