Error and Warning Messages
HP NonStop TMF Management Programming Manual—540140-008
7-56
Archive Tape Errors and Warnings
8006 The DEVICE attribute of the tape ZART-TKN-DEFINENAME specifies a
drive, ZART-TKN-DEVICENAME, whose system either does not exist
or is inaccessible because all paths to it are down.
A tape drive was specified with a DEFINE whose system either does not exist or
is unavailable.
8007 The SYSTEM attribute of the tape DEFINE ZART-TKN-DEFINENAME
specifies a system, ZART-TKN-SYSTEMNAME, that is on a pre-C00
operating system.
A system was specified with a DEFINE that is not running a C00 or later RVU
of the operating system.
8008 The DEVICE attribute of the tape ZART-TKN-DEFINENAME specifies a
drive, ZART-TKN-DEVICENAME, whose system is on a pre-C00
operating system.
A tape drive was specified with a DEFINE whose system is not running a C00 or
later RVU of the operating system.
8009 The SYSTEM attribute of the tape DEFINE ZART-TKN-DEFINENAME
specifies a system, ZART-TKN-SYSTEMNAME, that does not have
labeled tape support configured.
A system was specified with a DEFINE that does not have labeled tape support
configured.
8010 The DEVICE attribute of the tape DEFINE ZART-TKN-DEFINENAME
specifies a drive, ZART-TKN-DEVICENAME, whose system does not
have labeled tape support configured.
A tape drive was specified with a DEFINE whose system does not have labeled
tape support configured.
8011 The tape DEFINE ZART-TKN-DEFINENAME specifies labeled tape
processing and labeled tape support is not configured.
The local system does not have labeled tape support configured.
8012 Duplicate volume ID found in the VOLUME attribute of the tape
DEFINE ZART-TKN-DEFINENAME.
The VOLUME attribute of the specified tape DEFINE clause contains a
duplicate volume name.
To Next Page
Loading...
Need help?
General