Error and Warning Messages
HP NonStop TMF Management Programming Manual—540140-008
7-71
Dump/Restore Errors and Warnings
9030 File-system error ZTMF-TKN-DR-FILEERROR occurred on file.
ZTMF-TKN-DR-FILENAME.
A file-system error occurred for the specified file.
The ZEMS-TKN-EMPHASIS token is set to TRUE.
9031 Operator requested termination.
The operator requested the termination of a dump or restore operation.
The ZEMS-TKN-EMPHASIS token is set to TRUE.
9032 File-system error ZTMF-TKN-DR-FILEERROR from the TMF Catalog.
A dump or restore process encountered a file-system error from the TMF
catalog.
The ZEMS-TKN-EMPHASIS token is set to TRUE.
9033 NonStop SQL error ZTMF-TKN-DR-FILEERROR occurred on file
ZTMF-TKN-DR-FILENAME.
An online dump or restore process received a file-system error from NonStop
SQL/MP.
The ZEMS-TKN-EMPHASIS token is set to TRUE.
9034 Requested tape BLOCKSIZE not supported; using 28KB instead.
If a tape device cannot handle the larger blocksize when requested, blocksize
28KB is used for the dump. A warning message is generated to the EMS
subsystem indicating this condition. For online dumps, the same warning
message is generated to the TMFCOM DUMP FILES command display.
The ZEMS-TKN-EMPHASIS token is set to TRUE.
9035 This tape was created with a BLOCKSIZE larger than 28KB, but this
drive does not support large transfers.
This message is displayed for online restores and audit restores if a
tape was dumped with a blocksize larger than 28KB and the tape
drive does not support large block transfers.
The ZEMS-TKN-EMPHASIS token is set to TRUE.
To Next Page
Loading...
