HP Officejet 4100 - Page 48

hp officejet 4100 series
chapter 6
42
to edit fax forwarding from the front panel
1 Press Setup.
2 Press 3, then press 8.
This selects the Basic Fax Setup menu, then selects the Fax Forwarding
Black Only option.
3 Forwarding is ON 1=Edit 2=Cancel appears on the display after a
moment. Press 1 to edit the number you wish to fax to or to change the start
and stop times. Follow the messages on the display.
to cancel fax forwarding from the front panel
1 Press Setup.
2 Press 3, then press 8.
This selects the Basic Fax Setup menu, then selects the Fax Forwarding
Black Only option.
3 Forwarding is ON 1=Edit 2=Cancel appears on the display after a
moment. Press 2 to cancel fax forwarding.
to edit or cancel fax forwarding from the director
1 In the Director, click Settings, click Fax Settings & Setup, and then choose
Fax Settings.
2 Click the Fax Forwarding tab.
Do one or more of the following as needed:
– To edit the phone number, click in the Forward Faxes to this Phone
Number box and enter the new phone number.
– To change the dates for forwarding edit the Start Forwarding and/or
Stop Forwarding calendars and time fields as needed.
– To cancel fax forwarding, clear the Forward Incoming Faxes to
Another Number check box.
3 Click Ok when the settings are changed.
use error correction mode
Error Correction Mode (ECM) eliminates data lost due to poor phone lines by
detecting errors that occur during transmission and automatically requesting
retransmission of the erroneous portion. Phone charges are unaffected, or may
even be reduced, on good phone lines. On poor phone lines, ECM increases
sending time and phone charges, but sends the data much more reliably. Turn
ECM off (the default setting is on) only if it increases phone charges substantially,
and you can accept poorer quality in exchange for reduced charges.
to change the ECM setting from the front panel
1 Press Setup.
2 Press 4, and then press 7.
This selects the Advanced Fax Setup menu, and then selects the Error
Correction Mode option.
3 Press to switch between Off and On.
4 Press Enter to use the setting you selected.