WLAN module
Description Spare part number
WLAN assembly RT CARTIER ac 2 × 2 (for products with NVIDIA N17E (GTX 1070/GTX 1060) 924813-855
Intel Dual Band Wireless-AC 9560 802.11 ac 2 × 2 WiFi + Bluetooth 5 Combo Adapter (non vPRO) LT22634-005
Before removing the WLAN module, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Base enclosure (see Base enclosure on page 45)
b. Battery (see Battery on page 38)
c. Optical drive (see Optical drive on page 48)
Remove the WLAN module:
1. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
NOTE: The WLAN antenna cable labeled “1” connects to the WLAN module “Main” terminal labeled “1”.
The WLAN antenna cable labeled “2” connects to the WLAN module “Aux” terminal labeled “2”.
2. Remove the Phillips M2.0 × 2.5 screw (2) that secures the WLAN module to the system board. (The WLAN
module tilts up.)
50 Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
