How to fix "Invalid system disk" or "Auto IDE error" on HP Laptop?
To resolve an "Invalid system disk" or "Auto IDE error" message on your HP Laptop, first check for a disk in the floppy drive. Then, check the boot order in BIOS Setup. Finally, remove and reinsert the hard drive. The issue might stem from the hard drive contacts or the hard drive itself.
What to do if my HP OmniBook 6100 beeps once, spins hard disk, repeats, but does not boot?
If your HP Laptop beeps once, spins the hard disk, repeats, but doesn't boot, make sure at least one SDRAM module is installed. The cause of this issue is often a missing or improperly installed SDRAM module.
What to do if files are corrupted on HP OmniBook 6100 Laptop?
If files on your HP Laptop are corrupted, run the VirusScan program. Check the disk surface by running Scandisk (Windows 95/98) or by using the Tools tab in the disk’s Properties sheet (Windows 2000). Test the hard disk drive with the e-Diagtools diagnostics. Use the Recovery CD to restore original factory software.
General| Processor | Intel Pentium III |
|---|---|
| Display Size | 14.1 inches |
| Display Type | TFT LCD |
| Battery Life | Up to 3 hours |
| Optical Drive | CD-ROM or DVD-ROM |
| Network | 10/100 Ethernet, 56K Modem |
| RAM | 64 MB - 512 MB |
| Display Resolution | 1024 x 768 pixels |
| Operating System | Windows 98, Windows 2000, Windows XP |
| Ports | USB, VGA, Serial, Parallel, PS/2 |
To Next Page
