1–4 Maintenance and Service Guide
Product Description
1.2 Resetting the Computer
If the computer you are servicing has an unknown password,
follow these steps to clear the password. These steps also
clear CMOS:
1. Enter an incorrect password and press
enter.
2. Repeat Step 1 two times.
After the third entry of the incorrect password, the computer
responds with a “System Disabled” message and provides an
override password.
3. Access MS/DOS by clicking Start > All Programs >
Accessories > Command Prompt.
4. Enter “unlock6 xxxxx 0,” where “xxxxx” is the password
generated by the computer in Step 2.
The computer responds with another system-generated
password. This password can be used to reset the computer
and clear all CMOS settings.
To Next Page
Loading...
Need help?
General
