d. Release the wireless antenna cable from the retention clips (3) and routing channel built into the right
side of the display back cover.
e. Remove the wireless antenna.
The wireless antenna is available using spare part number L52052-001.
15. If it is necessary to replace the G-sensor module:
a. Remove the display panel assembly.
b. Detach the G-sensor module (1) from the display back cover. (The G-sensor module is attached to
the enclosure with double-sided adhesive.)
c. Release the adhesive support strip (2) that secures the EDP cable to the G-sensor module.
48 Chapter 5 Removal and replacement procedures
To Next Page
Loading...
