d. Release the ZIF connector (3) to which EDP cable is connected, and then disconnect the EDP cable
from the G-sensor module cable.
e. Remove the G-sensor module.
The G-sensor module is available using spare part number L52057-001.
16. If it is necessary to replace the EDP cable:
a. Remove the display panel assembly.
b. Remove the display panel cable.
c. Remove the display left hinge.
d. Remove the wireless antenna.
e. Remove the G-sensor module.
f. Disconnect the EDP cable (1) from the webcam/microphone module.
g. Release the shielding material (2) that secures the EDP cable to the display back cover.
h. Release the EDP cable from the retention clips (3) and routing channel built into the left side of
the display back cover.
Component replacement procedures 49
To Next Page
Loading...
