Front USB Assembly
Description Spare part number
Front I/O and card reader (6-in-1) 656983-001
The front USB assembly is secured to the front of the chassis with one screw. Push the assembly into
the chassis to remove it.
1. Prepare the computer for disassembly (
Preparation for Disassembly on page 80).
2. Remove the access panel (
Access Panel on page 81).
3. Remove the front bezel (
Front Bezel on page 83).
4. Disconnect the four cables from the system board as follows:
●
Yellow connector labeled F_AUDIO
●
White connector labeled MINI_LED
●
White connector labeled F_USB3
●
Black connector labeled F_USB2
Figure 8-26 Disconnecting the front I/O cables
104 Chapter 8 Removal and Replacement Procedures – Small Form Factor (SFF) Chassis
To Next Page
Loading...
