EasyManua.ls Logo

HP Pro 6305 - Aligning Drives in a RAID Configuration; Using Third-Party Deployment Tools; Enhancing Performance with Many Small Writes (as with Imagex); Validating Partition Alignment

HP Pro 6305
21 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
Aligning drives in a RAID configuration
If two or more Advanced Format drives have been configured for RAID, running the Paragon Partition
Alignment Tool on these drives aligns partitions at 2,048 sectors. Since a starting offset of 2,048
supports most stripe-unit sizes, performance would be enhanced
6
due to the elimination of redundant
disk operations.
Running the Paragon Partition Alignment Tool ensures support for the stripe-unit sizes associated with
most RAID configurations, including RAID 0, 1, 5, and 10.
7
If you wish to perform an unattended deployment for an aligned partition in a RAID configuration,
you can use DiskPart or ImageX as long as the RAID volume had been set up before creating
partitions and applying the image.
Using third-party deployment tools
Deploying an OS that is Advanced Format-aware (such as Windows 7) with a third-party deployment
tool that is not Advance Format-aware may result in misalignment. Moreover, if you were to boot to
an OS such as Linux or DOS, the partitioning tool may not be Advanced Format-aware in that
particular environment.
Contact the vendor for requirements for running their deployment tool.
Enhancing performance with many small writes (as with ImageX)
While Windows 7 SP1 and WinPE 3.1 are already optimized, Microsoft Knowledge Base article
KB982018 addresses performance degradation associated with a Windows 7 or WinPE 3.0 system
performing many small writes to an Advanced Format drive. For example, using the ImageX
command-line tool while booted to WinPE to apply a Windows image (.wim file) to an Advanced
Format drive would take significantly longer than applying the same image to a traditional hard drive.
To optimize Windows 7 performance, you should apply the KB982018 hotfix to your HP system, as
described in the article.
For WinPE 3.0, IT professionals can install KB982018 by following the procedure described in
Appendix B: Procedure for installing KB982018 into WinPE 3.0.
Validating partition alignment
This section outlines the following options for validating partition alignment:
Using the Unattended Advanced Format Hard Disk Information Tool
Using Microsoft DiskExt (for Windows XP or later platforms)
Using the Windows Management Information Command-line (WMIC) utility (for Windows XP or
later platforms)
Using DiskPart (for Windows 7 platforms)
Sample calculations are also provided.
6
Compared to a scenario with misaligned drives
7
Ultimately, alignment depend on stripe-unit size; however, 1 MB (2,048 sectors) alignment fits most RAID stripe-unit sizes.

Related product manuals